Conclusions and recommendations
If there are not any recommendations to be manufactured due to the project, call this section just Conclusions.
The Conclusions section sums up the important thing points of your discussion, the essential features of your design, or the significant outcomes of one’s investigation. As the function is to round the story off of assembling your project, it will:
- be written to relate directly to the aims of the project as mentioned within the Introduction
- indicate the extent to that your aims have already been achieved
- summarise the findings that are key outcomes or information in your report
- acknowledge limitations and work out recommendations for future work (where applicable)
- highlight the value or usefulness of your work.
The conclusions should relate solely to the aims for the work:
The goal of this project would be to design a mobile phone tower for a suburban location..
The mobile phone tower presented here can be erected safely in a suburban street.
It requires an overall total part of no more than 2m 2 l, and has the following safety features.
This investigation will review the amount of passengers making use of the Monash University Clayton-Caulfield inter-campus bus so that you can recommend adjustments into the service if required.
Analysis regarding the survey data obtained in this project indicates that use of the Clayton-Caulfield inter-campus bus has increased by 24% in past times 5 years. It is suggested that frequency be increased during peak usage.
The Conclusions section below is from a known level 2 Civil Engineering Alternative Designs report presenting two designs for a an overpass bridge. Click on the buttons that are coloured see the comments.
Each of the two bridge designs Lecturer’s comment:
An elegant beginning for a Conclusions follows on neatly from the discussion that is preceding. In this full case, moreover it indicates that the aims associated with project have been met. presented in this report fulfil the criteria specified into the project brief. Both designs Lecturer’s comment:
The main findings or outcomes – in this case the important thing options that come with the designs – are then recapped. incorporate round piers on piled foundations, that are used since the soil conditions are unknown and possibly unstable. Design 1, a simple composite I-girder bridge, has the benefit of being made from steel and thus has longer spans and fewer piers.
Design 2, a super-T beam br >Design 2 Lecturer’s comment:
The need for the end result – in this instance the final recommendation – is obviously stated. is therefore recommended. It includes Lecturer’s comment:
To finish off, the achievement of this project is reinforced. An overpass that is affordable superior durability, and fully meets what’s needed associated with design brief.
Always address limitations essay writers and suggest how they may be overcome in the future work. The below that is excerpt from the Conclusions of a study on a project investigating the end result of pulsation on heat transfer in horizontal pipe flow.
Experimental results Lecturer’s comment:
Key conclusions drawn through the project. indicated that pulsed flow without flow reversal had no significant effect compared with steady flow. Preliminary experiments with reversed flow, however, clearly indicated increased heat transfer. That is likely due Lecturer’s comment:
Provide a possible explanation for notable results, especially unexpected ones. to your large disturbances within the boundary that is hydrodynamic once the flow changes direction. Further research Lecturer’s comment:
Recommend further research to deal with any extra work you think will be useful. is preferred to determine the most enhancement that is achievable.
It should be noted that Lecturer’s comment:
Acknowledge limitations or errors and suggest explanations solutions that are and/or. the experimental results usually do not agree with the equations that are theoretical. This might be due to the deposits which developed in the pipe, or even to thermocouple temperature that is inconsistent. Therefore, regular inspection for the test rig is advised.
For a tremendously report that is long it really is acceptable to present the conclusions and recommendations in point form:
The prototype robot courier presented here has been confirmed to allow you to delivering documents autonomously in an office environment. It has demonstrated the following the different parts of mobile robotics:
- Localisation: The Kalman filter-based localisation algorithm achieved sub-centimeter accuracy under normal operating conditions.
- Environment modelling: The occupancy map was updated dynamically to include obstacles not included in the original map.
- Path planning: A distance path that is transform-based using obstacle transforms produced a globally optimal local entrapment-free way to the target.